Mec Aerial Work Platforms

The Role of Aerial Optical Cables on Power Poles

Deploying fiber above ground on poles or towers removes the need for underground digging and is particularly useful when the ground is uneven, rocky or both. The last mile of Fiber to the Home (FTTH) and Fiber to the Cabinet (FTTC) aerial fiber deployments often run through crowded environments, where space is at a premium. The messenger gives the cable a sufficient tensile strength and resistance to strain. If we want to install the fiber optic cable on a path that already has support and don't have to worry about the span of the fiber optic cable. Most aerial fiber optic cables are installed by lashing to a steel messenger wire strung between poles, but there is a category of cables with special high-strength jacket designs called all-dielectric self-supporting (ADSS) cables. ADSS cables are designed to withstand very high-tension loads.

[PDF Version]

Outdoor aerial optical cables are reliable

Outdoor fiber optic cables are designed to withstand the harsh outdoor environment. Whether you're linking buildings, running broadband in rural areas, or building 5G infrastructure, the right cable matters. It affects performance, maintenance, cost, and reliability. In the global expansion of optical communication networks—including FTTx access, rural telecom coverage, long-haul backbone links, and smart power grid construction—aerial fiber optic cable has become one of the most practical and widely used transmission mediums. As the backbone of modern telecom infrastructure, these cables come in specialized designs to operate reliably despite the challenges of humidity, tension, wind, rodents. Selecting the right outdoor fiber cable is crucial for ensuring reliable and efficient fiber optic communication in outdoor environments.

[PDF Version]

Can the optical flow module work at night

Many successful optical flow estimation methods have been proposed, but they become invalid when tested in dark scenes because low-light scenarios are not considered when they are designed and current optical flow bench-mark datasets lack low-light samples. Optical Flow uses a downward facing camera and a downward facing distance sensor for velocity estimation. It can be used to determine speed when navigating without GNSS — in buildings, underground, or in any other GNSS-denied environment. The video below shows PX4 holding position using the Ark. This article describes how to setup the PX4FLOW (Optical Flow) Sensor which can be used for Non-GPS navigation. The PX4FLOW is not yet supported in Plane or Rover. The sensor has a native resolution of 752×480 pixels, a 4-fold grading and cropping algorithm is used to calculate the optical flow, the calculation speed reaches 250Hz (daytime, outdoor), and it has a very high sensitivity. The product page says: - The Maximum range of VL53L0X is 2m, Altitude hold 0~2m @ throttle 0~100% if VL53L0X is enabled.

[PDF Version]

Can single-sheathed ASS fiber optic cables be used for aerial applications

In sensing applications, the potential of signal noise must be eliminated. Sheathings designed to be totally opaque (PVC, silicone) should be considered, and in the case of multi-channel construction, bot.